R13

In-Line pressure regulator with factory-set outlet pressure, reducing from e.g. 10 bar to 5 bar.
The regulator R13 is suited for basic pressure control only with an outlet pressure tolerance of ±30%.
The outlet pressure stated below is valid for 12 bar inlet pressure. For other inlet pressure please
refer to the according item from the diagram.

Benefits:
• Higher safety through lower pressure. Tools and equipment protected against pressure damages.
• Cost reduction through substantially reduced air consumption. Longer service life.
• Noise reduction for tools.

Media: compressed air or non-corrosive gases
Supply pressure: max. 15 bar

Adjustment:
Select the pressure regulator according to the desired outlet pressure. The outlet pressure cannot be
subsequently adjusted. This safeguards against tampering.

Relieving function: non-relieving, therefore not recommended for applications such as nailers

Temperature range:
0 °C to 60 °C / 32 °F to 140 °F, for appropriately conditioned compressed air down to -30 °C / -22 °F

Body: brass
Elastomer: NBR/Buna-N, optionally FKM